CISCO EIGRP COMMAND AND CONFIGURATION HANDBOOK PDF

INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE . interface configuration command to instruct EIGRP to use the received . Therefore, to connect disparate EIGRP sites, you must configure the neighbor command with LISP encapsulation on every CE in the network. Cisco Nexus Series NX-OS Unicast Routing Configuration Guide, .. The { ip | ipv6} passive-interface eigrp command suppresses neighbors from forming.

Author: Ball Zulabar
Country: Ukraine
Language: English (Spanish)
Genre: Personal Growth
Published (Last): 9 January 2006
Pages: 76
PDF File Size: 20.3 Mb
ePub File Size: 8.48 Mb
ISBN: 747-3-30488-363-6
Downloads: 98026
Price: Free* [*Free Regsitration Required]
Uploader: Kajikus

EIGRP Configuration With Packet Tracer ⋆

Enable IPv6 routing using ipv6 unicast-routing command. There are lot more similarities than differences, so it makes sense to list confiiguration few differences that exist between the two protocols. NOTE If a path is not a feasible successor, it is commane used in load balancing. Houston config-keychain-key key-string tower Identifies the key string. One incoming global distribute list One outgoing global distribute list One incoming interface distribute list One outgoing interface distribute list One outgoing redistribution distribute list.

Topology entry for The configuration settings are made with the maximum-paths and variance commands in EIGRPv6 router configuration mode, reached with the ipv6 router eigrp command.

  GEOTERMALNE ELEKTRANE PDF

EIGRP configuration

Router config-router network Houston config-router key chain eddie Identifies a key chain name, which must match the name configured in interface configuration mode. Houston config-router network Inbound and Outbound Distribute List Route Filters Figure shows the network topology for the configuration that follows, which demonstrates how to configure inbound and outbound route filters to control wigrp updates using the commands covered in this chapter.

Set eifrp bandwidth and delay to influence metric calculation interface configuration mode.

R1 show ipv6 eigrp topology No neighbor adjacency will be formed. About Affiliates Cisco Systems, Inc. No neighbor adjacency will be formed.

If the parameters do match, the two routers become neighbors and each router adds the other to its EIGRPv6 neighbor table, as listed with the show ipv6 eigrp neighbors command.

NOTE With the maximum-paths router configuration command, up to 32 equal-cost entries can be in the routing table for the same destination.

13-4 EIGRP for IPv6

See All Related Articles. See All Related Articles. Figure shows the network topology for the configuration that follows, which demonstrates how to configure inbound and outbound route filters to control routing updates using the commands covered in this chapter. Both the routes have an AD 90 and metric and are listed on two separate lines. Houston config-if clock rate Sets the clock rate.

  COMPACT PERIPHERAL COMPONENT INTERCONNECT CPCI PDF

However, this omission means that EIGRPv6 is not enabled on the interface, and therefore the router will not advertise about that connected subnet. Austin config-router no auto-summary. Austin config-if no shutdown Enables the interface.

Houston config-router no auto-summary Disables auto-summarization. See All Related Articles. Router config-router distribute-list 5 out ospf 1.

For instance, you could have two routers advertise the same network— Austin config-if ip authentication key-chain eigrp susannah. The remote subnet Houston config-router key chain eddie.

Houston config-keychain-key send-lifetime Houston config-if ip authentication key-chain eigrp eddie. You may use the show ipv6 eigrp cisdo command to verify if EIGRPv6 has been enabled on correct interfaces:. Austin copy running-config startup-config.

Creates a standard ACL number 20 and explicitly denies the The subnet has one successor, which has an FD feasible distance of Once two EIGRPv6 routers become neighbors, they should exchange all appropriate network topology information.